Subscribe to Our Youtube Channel
Related Manuals for Kodak 70
Summary of Contents for Kodak 70
- Page 1 Multi-Feed Detector For use with the: Document Scanner 9500 Document Scanner/Microimager 990 Kodak Imagelink Scanners 900 and 923 Kodak Imagelink Microimager 70 User’s Guide A-61120 Part No. 1E8110...
-
Page 2: Before You Begin
For a microimager, be sure the Advanced Document Controller* and skew detection is installed and enabled in the desired mode. * All Kodak Digital Science 9000 series Document Scanners and Kodak Imagelink 900 series Scanners come with the Advanced Document... - Page 3 Enabling/disabling the Multi-Feed Detector Labels should be placed on the documents so they do not pass under the thickness sensor. If the labels on the document will pass under the thickness sensor, they must be less than or equal to ½-inch in length and spaced greater than 1 inch.
- Page 4 The lights do not change. When a multi-feed is detected, both buttons illuminate. Depending upon the scanner or scanner/microimager firmware and how the unit is configured, one of the following messages will be displayed: MCP Version 8.40 or greater displays the following message:...
- Page 5 - reset the document stack - start the transport again If the scanner is setup to beep and display an error or just display an error, an E107 message will be displayed. The transport will continue to run, and both Multi-Feed Detector indicators will be illuminated.
- Page 6 3. Press the extended portion of the sensor in until it snaps up into the retracted position. NOTE: The Multi-Feed sensor is located approximately 1 inch left of the feeder centerline as you face the scanner. 4. Place the feeder top back into its original position. 5. Close the front cover.
-
Page 7: Error Recovery
4. When using the Document Scanner/Microimager 990 or Microimager 70, determine the image address of the document that produced the last successfully scanned image (documents that have been successfully scanned and stored in the image buffer have been microfilmed). -
Page 8: Troubleshooting
Multi-Feed Detector buttons may be continually illuminated and an E204 error is displayed on the operator interface. Both Multi-Feed Detector buttons are constantly illuminated: The scanner has encountered a multi-fed document, or the document missed the sensor. Depending upon the scanner configuration, the transport will stop and display an E204 error;... - Page 9 Condition Skewed document, not a multi-feed Calibration — both lights continue to flash Both Multi-Feed Detector buttons are not constantly illuminated: Encountered a skewed document. Press the green Run button to continue. Document feed missed the sensor during calibration. Refeed the document so it passes under the sensor to complete the calibration.
- Page 10 A-61120 3/99 © Eastman Kodak Company, 1999 Printed in U.S.A. EASTMAN KODAK COMPANY Document Imaging Rochester, New York 14650 Kodak, Imagelink, Digital Science and the ds monogram symbol are trademarks of Eastman Kodak Company. Printed on recycled paper. DOCUMENT I M A G I N G...
Need help?
Do you have a question about the 70 and is the answer not in the manual?
Questions and answers