Field; A-61124 March - Kodak Document Scanner 9500 with Image Manager Integrator Manual

BX/Y/Z — Scan resolution
CX — Clear buffers
DC — Sequential ID
initiator

A-61124 March 1999

The BX/Y/Z command defines scanning resolution for the current
mode.
Data Field
Data Field
res scan resolution in dots per inch
* Values must be specified in increments of 10 dpi. If not, values will be
rounded to the nearest 10 dpi by the scanner.
NOTE: Leading zeros are not permitted.
The CX command resets the image buffer and initializes the
Sequential ID Number to 1. This command is intended for use
only during integration testing and should not be used in a
production scanning application.
IMPORTANT: Executing the CX command may cause images in
the buffer to be lost. Similarly, if the command is
executed while there are documents in the
transport, the new images may also be lost.
Data Field
none
The DC command is used to set the Sequential ID Number
(document count).
Data Field
cnt
Data Field
cnt image number value
level
The following example shows how the DC command could be
used:
The host application wants the starting image Sequential ID
Number (document count) to be 101.
The Sequential ID Initiator command must enter a value one less
than the desired starting value (to start with 101, the cnt value
must be 100).
HEX 31
CHAR 1
res
Description
Command Field
Command Field
level
Description
30 30 39
0 0 9
Command Field
B X/Y/Z
Value(s)
70 to 300*
C X
D C
Value(s)
0–999999999
9
44 43
D C
6-5