Configuration Via Web; Global Port - Ovislink Wireless Router User Manual

CONFIGURATION VIA WEB

Before you start setting up this device via the browser-based web configuration, make
sure:
∗ Assuming the workstation's TCP/IP is set to obtain IP automatically and the
Device's Local Port is set to "Distribute IP" (default), and all the cables are
connected correctly, you are now ready to configure this device via Web Browser.
Open the browser, enter the local port IP address of the Device (default at 192.168.1.
254), and click "Go" to get the login page.
User name: not required.
Password: default is left blank. If you have set a password, enter that and click OK to
continue.
Figure 4
At the setup home page, the left navigation pane where bookmarks are provided links
you directly to the desired setup page. You can select Global Port, Local Port,
Management, Virtual Server, Packet Filter, Static Router, Checking E-Mail, Dynamic
DNS, Network Status (WAN IP Status, Session List, Users List), Factory Reset, Save
Configuration, Firmware Upgrade.
Click on the desired setup item to expand the page in the main navigation pane. The
setup pages covered in this utility are described below.

Global Port

The opening screen contains settings for the Global (Internet connection) interface.
Click on the down arrow ? to select the desired Internet connection mode on the list.
Obtain configuration
automatically (CATV dynamic
mode)
PPPoE (DSL dynamic mode)
OvisLink
For users who are using Cable
Modem Internet service.
For users who are using xDSL
Internet service that runs PPPoE. If
your xDSL service uses PPPoE, after
- 6