Table of Contents
Advertisement
6. Mounting holes
*1) Note:
Applicable C-mount lens should be designed for 3-CCD cameras.
C-mount lens must be less than 4mm.
Be advised: when using a lens with the iris diaphragm fully open, vignetting on corners
may occur.
*2) Note:
When a Camera Link
tighten screws by using a driver. The Camera Link
damaged. For security, the strength to tighten screws is less than 0.291 Newton meter
(Nm). Tightening by hand is sufficient in order to achieve this.
*3) Note:
The tripod adapter plate MP-41 can be used.
AT-200CL
8 x M3 depth 5mm for tripod mount plate or direct installation *3)
®
cable is connected to the camera, please do not excessively
Fig. 1. Locations
- 8 -
Rear protrusion on
®
receptacle on the camera might be
Advertisement
Table of Contents
