Controlling Audio; 3-Way Speaker System Setup - Kenwood DNX9190DABS Instruction Manual

Controlling Audio

You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU]/[ ] button.
h Popup menu appears.
h
2
Touch [Audio].
See the following section for each setting.
• Set up speaker / X'over (P.82)
• Controlling equalizer (P.84)
• Set listening position / DTA (P.88)
• Controlling general audio (Fader /
Balance) (P.84)
• Set volume offset (P.85)
• Performing zone control (P.86)
• Set sound effect (P.87)
• Memory/recall the audio settings
(P.89)

3-way speaker system setup

(Except DNX419DABS)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [HOME]/[ ] button.
h HOME screen appears. h
2
Touch [
].
h Source selection screen appears.
h
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
DNX9190DABS / DNX7190DABS
2
DNX5190DABS
2
1
h Speaker system select screen appears.
h
5
Select the crossover network mode.
h A confirmation screen appears. h
6
Touch [Yes].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
Autogoods "130"
Controlling Audio
1
DNR4190DABS /
DNR3190BTS
2
1
81
English