State Activity - Planet FGSD-1022P User Manual

4.6.3 State Activity

Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity for the members of
the LACP trunk group. You can tick or cancel the checkbox beside the state label. When you remove the tick mark of the
Apply
port and click , the port state activity will change to Passive.
The page includes the following fields:
Object
Active:
Passive:
A link having two passive LACP nodes will not perform dynamic LACP trunk because both
ports are waiting for an LACP protocol packet from the opposite device.
Figure 4-6-7: State Activity of
Description
The port automatically sends LACP protocol packets.
The port does not automatically send LACP protocol packets, and responds only
if it receives LACP protocol packets from the opposite device.
105
User's Manual of FGSD-1022 Series
Switch 1