Lucent Technologies 6400 Series User Manual page 20

Abbreviated Dialing (AD)
3. If you are using a telephone with a display, press the Menu button
and then press the softkey below Prog.
If your telephone does not have a display or if Prog is not available
on your display, press the
OR, Dial the AD Program access code __________. [dial tone]
4. Press the AD button to be programmed.
5. Dial an outside number, extension, or feature access code you want
to store.
Note: If the programmed number is associated with a list, it can be
up to 24 digits. If the stored number is NOT associated with a
list (that is, an Automatic Dialing button), it can be up to 16
digits. See your system manager if you need help.
Note: If your telephone has a display, you may be able to use the
softkeys to add special functions such as Pause, Mark, or
Wait into the telephone numbers programmed on the AD
button.
If you are programming an outside number, be sure to include
a trunk code, if applicable.
6. Press # .
Number is stored.
7. Repeat Steps 4 through 6 to program additional buttons.
8. Hang up to end programming.
To place an AD call
1. Press the selected AD button.
Call is automatically dialed.
To program or reprogram an outside number, extension, or feature
access code into an AD personal list
1. On a separate sheet of paper, write down the outside numbers,
extensions, and/or feature access codes you want to program as
items on your personal list(s).
Note: Each phone number or feature access code is stored as a
separate item.
2. Pick up the handset or press
Note: If you are using the built-in speakerphone, you must press a
call appearance button before you begin Step 3.
(continued)
Program
[confirmation tone]
16
button (if administered)
.
Spkr
continued on next page