Error Responses; Symbol Definitions - Extron electronics FOX T USW 103 User Manual

Error responses

When the FOX T USW 103 receives an SIS command and determines that it is valid, it
performs the command and sends the corresponding response to the host device. If the
command is determined invalid or contains invalid parameters, the switcher or receiver
returns an error response to the host. The error response codes are:
= Invalid input number
E01
= Invalid switch attempt in this mode
E06
= Invalid command
E10
= Invalid port number
E12
Using the command and response table for SIS commands
The Command and Response Tables
acceptable in the command field except where indicated. Figure 9 shows the hexadecimal
equivalent of ASCII characters used in the command and response tables.
ASCII to Hex Conversion Table
Space
Figure 9. ASCII to Hexadecimal Conversion

Symbol definitions

= Carriage return and line feed
]
¦ = Carriage return with no line feed
}
or
= Space
•
= Escape key
E
or W
= Invalid parameter
E13
= Not valid for this configuration
E14
= Invalid command for signal type
E17
= Busy
E22
begin on page 15. Lowercase letters are
•
FOX T USW 103 Universal Switcher • Remote Control 13