Table of Contents
Advertisement
Configuring a Serial Pass-through Group
NOTE:
1.
Decide which device is to be the server.
2.
On the device list page (see
configure.
3.
On the device page (see
4.
On the peripherals page (see
client
If you select client, the destination drop-down box (
Configuring the Server
Figure 41.
5.
Configure the baud rate, data bits, stop bits, parity, and handshake settings as required
b
(
).
6.
In the destination drop-down box, select
7.
Click the
8.
Repeat steps 2 through 7 for all
9.
Click the
NOTE:
The client and server ends of the serial pass-through connection do not have
to have the same baud rate settings, however having the different ends at
vastly different rates can result in unexpected results.
figure 23
figure 25
a
on figure 41), set the mode to either
.
1
4
2
2
2
2
2
Configuring a Serial Pass-through Group
d
button (
).
update
tab to save the changes.
Save All
If you do not click
Save All
and off.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation
on page 32), click on the device you want to
on page 34), click the
peripherals
c
) appears.
Configuring a Client
for the appropriate server (
passthrough
, the settings are lost when power is cycled on
tab.
or
server
1
4
2
2
2
2
2
3
c
).
52
Advertisement
Table of Contents
