Table of Contents
Advertisement
Configuration Page — Video Encoder
The video encoder configuration page (see figure 26) is accessed by clicking the video
icon in the configuration panel of the device page and consists of two panels. This page
also provides access to the bandwidth management page via the
"Bandwidth Management Page and Typical Bit
1
2
Figure 26.
The top panel of the video encoder configuration page (
following information:
Name — This field displays the name that is applied to the video port, that is, the name
•
of the image stream. The name is displayed next to the video icon in the configuration
panel of the device page. Note that this need not be the same as the name applied to
the physical unit itself. You can change the name to a more meaningful value for your
installation. Change the device name as follows:
1.
Highlight the existing device name.
2.
Type the new name.
3.
Click the
NOTE:
•
Input Mode — The VN-Matrix 325 codec supports a fully automatic detection of the
connected signal format. No manual configuration is required.
Current Mode — This value reports the currently detected source type.
•
•
Source Status — This value reports the status of the input connection.
Unplugged
•
is present.
Active
•
Streams panel
The bottom, Streams, panel of the video encoder Configuration page (
provides details of any active video encoder streams. The data transport method, TCP or RTP,
is defined on the decoder configuration page (see
Multicasting is selected on this page (see
multicast and
The
New Export Stream
Video Encoder Configuration Page
button.
update
Spaces within names can cause issues when controlling the system
using a third-party control system. Extron recommends avoiding spaces
within names..
— Indicates that either there is no source connected or no invalid video
— Indicates that a valid video connection is present.
"Data Transport
Methods" for definitions of the methods).
function is not supported.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation
Bandwidth
Rates").
a
on figure 26) provides the
"Configure Encoders or
"Enable multicast
streaming" to select the
tab (see
b
on figure 26)
Decoders").
37
Advertisement
Table of Contents
