Table of Contents
Advertisement
Configure Encoders and Decoders
NOTE:
After the low-level configuration described on
is via the network interface (built-in HTML pages) of the unit designated as the controller.
The pages can be viewed by any web browser, such as Mozilla Firefox, version 4.0 or newer
(preferred), or Microsoft Internet Explorer, version 6.0 or newer, provide access to various
system parameters.
NOTE:
Startup and Login
1.
2.
3.
Perform the procedures in this section after you connect all codecs in the system
to a network.
Whichever browser you use, it must be configured to accept cookies and be
JavaScript-enabled.
Connect a computer to the same network as the VN-Matix 325 device that is configured
as the controller.
NOTE:
The computer must be on the same subnet as the VN-Matrix 325 units.
In the web browser, enter the IP address of the VNC 325 that is configured as the
controller into the address bar of the web browser (see figure 15).
3
5
6
Figure 15.
Controller Login via the LAN Port
Press <Enter>. The login screen appears.
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
page
17, system configuration and operation
25
Advertisement
Table of Contents
