Configuring Network Settings; Serial Port Wiring - Extron electronics VN-Matrix 325 User Manual

Table 4 shows the codec configuration settings for example 3. See
Settings" on page 16 to make these settings.
Table 4.
Codec 1
Option LAN Port 1 (RJ-45)
Codec 2
Option LAN Port 1 (RJ-45)

Configuring Network Settings

NOTE:
Connect a computer to the Remote port (
for that unit. Set one codec in the system as the controller.
See"Serial Port
See

Serial Port Wiring

Figure 9 shows how to connect a host device to the Remote port (
Figure 9.
NOTES:
Applicable Codec Configuration Selections
2 Address: 172.28.0.1
3 Netmask: 255.255.0.0
2 Address: 172.29.1.1
3 Netmask: 255.255.0.0
Perform the procedures in this section before you connect any codec to a
network.
Wiring", below to make a cable for Remote port.
"Configure Network Settings" to configure the network settings.
Pin RS-232 Function
1 DCD Data character detect
2 RX Receive data
REMOTE
1 5
3 TX Transmit data
4 DTR Data terminal ready
5 Gnd Signal ground
6 DSR Data set ready
6 9 7 RTS Request to send
8 CTS Clear to send
9 Ring Ring indicator
Pin Assignment for the Remote Port
• The VNC 325 uses 9-pin D male connectors. You may need an adapter.
•
The RS-232 protocol for the Remote port is as follows:
Baud rate: 115200
Stop bits: 1
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
Option LAN Port 2 (fiber optic)
12 Address: 192.168.1.1
13 Netmask: 255.255.255.0
14 Gateway: 192.168.0.250
17 Controller ip: 192.168.1.1
Option LAN Port 2 (fiber optic)
12 Address: 192.168.1.1
13 Netmask: 255.255.255.0
14 Gateway: 192.168.1.250
17 Controller ip: 192.168.0.1
a
) on each unit to configure the network settings
Data bits: 8 Parity: None
Flow control: None
"Configure Network
a
).
16