Table of Contents
Advertisement
Configuration Selections
NOTES:
Table 5.
LAN Port Specific Options
Option
0
10
1 and 11 Boot method:
2 and 12 address:
3 and 13 netmask:
•
In a typical installation, you:
Must change the address (
•
(
4
or
14
), and controller IP (
May need to change the boot method (1 or 11).
•
•
Most installers do not need to change the other selections. If you do change
settings, note the existing values before the change in case you need to
change back.
•
Options
through
are the settings for LAN port 1 (the RJ-45 port).
0
6
•
Options
through
are the settings for LAN port 3 (the optical port).
10
16
•
Options
through
,
, and
7
9
17
•
Selections marked with an asterisk (*) in options
default VNC 325 hardware settings and the correct selection in most cases.
Configuration Selections
Function
Comments
Speed/Duplex:
Allows you to set the speed of the RJ-45 LAN port manually
LAN port 1 link speed
using the following subselections:
*
1.
2. auto_10_100
3. fixed_1000F
4. fixed_100F
5. fixed_100H
Speed/Duplex:
Allows you to set the speed of the optical LAN port manually
LAN port 2 link speed
using the following subselections:
6. fibre_auto_1000
*
7.
Entering 1 (11) toggles this option. When DHCP is selected
Set static or dhcp
items 2 (12) through 5 (15) are not accessible.
NOTE: Extron recommends that you use static IP addresses.
Standard Ethernet IP addressing rules apply.
•
Set the local address
Manually enter the IP address for the port; use no leading
•
of the LAN port
zeroes. For example: 192.168.0.1 is valid, 192.168.000.001
is not valid.
Standard Ethernet subnet rules apply.
•
Set the appropriate
Manually enter the IP address for the port; use no leading
•
subnet mask for the
zeroes. For example: 255.255.10.0 is valid, 255.255.010.0
network.
is not valid.
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
or
), netmask (
or
2
12
3
7
).
are controller related.
18
0
and
auto_10_100_1000
fibre_fixed_1000F
), gateway address
13
10
below are the
19
Advertisement
Table of Contents
