Table of Contents
Advertisement
Configure the Units as Encoders or Decoders
A typical VN-Matrix 325 network (see figure 17) includes an encoder (source), a decoder
(display), and a controlling PC. The data transport method, TCP or RTP, is defined on
the decoder configuration page. Multicasting is selected on the encoder configuration
page (see
"Enable multicast
Methods" for definitions of the methods).
Encoded Video and Control
Encoder Configuration
POWER
OPTICAL
12V DC
1
LAN
3A MAX
Digital Video Source
Figure 17.
The Mode column on the Device List page (see figure 18) shows how each VNC 325 unit is
configured using the following icons:
= Encoder
NOTE:
Figure 18.
NOTES:
streaming" to select the multicast and
Network
REMOTE
RS-232
OVER LAN
2
Optional
Local
Monitor
Typical VN-Matrix 325 System
= Decoder
If this is the initial setup, none of the devices have been defined and thus show
the
icon in the Mode column.
Selecting a Device
•
The VNM Recorder is not documented in this guide. Inclusion in this list is for
completeness and reference only.
•
Only devices that are or have been configured to connect to the system
controller (using the procedure detailed in
are listed.
•
The device list may show more devices than are in your system. This is because
the controller maintains a list of devices that have been used in the past and are
not currently available. In this case, the IP address entry for that device is blank.
•
If desired, remove devices that have been physically removed from the system
from this listing by clicking the Delete icon ( ).
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
Encoded Video
Decoder Configuration
REMOTE
POWER
OPTICAL
12V DC
1
LAN
2
3A MAX
Decoded
Video
Control and
Monitor
Monitoring
= VNM Recorder
"Configuring Network
"Data Transport
RS-232
OVER LAN
= Undefined
1
Settings")
27
Advertisement
Table of Contents
