6.
Type the default password
the configuration menu (see figure 10).
NOTES:
The IP addresses and other variable shown in figure 10 are for illustration
•
only and may not match those on your unit.
•
Many menu selections are not available if DHCP is selected. Select option
or
to toggle DHCP on and off.
1
11
•
This procedure identifies the selections that you may need to make for
typical low level configuration only. See
for details on all available selections.
LAN Port 1 (RJ-45,
Network Port 1
==============
0. Speed/Duplex: auto_10_100_1000
1. Boot method:
static [dhcp]
2.
address:
3.
netmask:
4.
gateway:
5.
broadcast:
6. mtu:
7. controller ip:
8. controller port: 5432
9. Exit
Please select an option:
Figure 10.
Configuration Menu
7.
Change the settings as needed as follows:
NOTES:
•
Do not include leading zeros when typing IP addresses. For example, type
192.168.0.104; do not type 192.168.000.104.
•
Settings that you need to change for a for typical low level configuration
operation are:
Address (option
•
Gateway (option
•
•
Once you have designated a codec as the controller using option
can access it via either of its LAN ports.
a.
Type the option number and <Enter>.
b.
Type the new setting and <Enter>.
c.
Once all the changes have been made, type
exit the menu.
8.
Repeat steps 1 through 7 for each VNC 325 unit in the VN-Matrix system. Assign the
same controller IP address to each unit.
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
config
and press <Enter>. The connected unit downloads
, on
figure
2)
4
Network Port 2
==============
10. Speed/Duplex:
11. Boot method:
192.168.0.104
12.
255.255.255.0
13.
14.
15.
1500
16. mtu:
192.168.0.101
17. ip forwarding: 0
18. webserver port:
2
or
12
)
•
or
)
4
14
•
and <Enter> to save all settings and
9
"Configuration
Selections"
LAN port 2 (Optical,
fibre_fixed_1000F
static [dhcp]
address:
192.168.1.2
netmask:
255.255.255.0
gateway:
broadcast:
1500
80
Netmask (option
3
or
13
Controller IP (option
)
7
7
)
5
)
, you
18