Table of Contents
Advertisement
Decoder Streams Configuration Panel
1a
1d
Figure 37.
For each change made in the decoder streams configuration panel, click the
Update
button in the video configuration panel to confirm the change.
Ä
Source stream selection — You can view the available active source (streams) by
opening the
•
Choose
NOTE:
•
Choose
•
Choose
NOTE:
You can define the names by renaming the appropriate encoder device.
Å
Audio checkbox — Enable or disable the transport of the audio content associated
with the selected video stream (the audio stream) by selecting the
If enabled, the selected audio stream is listed adjacent to the
bandwidth list. If
û
Fec checkbox — Enable or disable the transport of the row (rowfec) and column
(colfec) content associated with the selected video stream by selecting the
box.
If enabled, the selected error correction streams are listed adjacent to the
colfec
NOTES:
ü
Bandwidth links — Click any of the
error correction), or
Streams
1b
1c
Decoder Streams Configuration Panel
drop down box.
Source
rtp(m)
for multicast RTP streaming.
is available only if you have enabled multicast streaming. See
rtp(m)
"Enable multicast
streaming" in the "Installation and Setup" section.
for unicast RTP streaming.
rtp
for unicast TCP streaming.
tcp
See
"Data Transport
Methods" in the "Installation and Setup" section for
more information.
is not enabled, the display is
Audio
headings in the bandwidth list. If
•
The encoder send error correction data only when it is enabled for
processing by a decoder.
•
Error correction data is sent only for the audio stream.
(row error correction), to open the
rowfec
Page", described on the next page.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation
audio
.
none
is not enabled, the display is
Fec
links,
,
Bandwidth
video
audio
"Decoder Bit Rate and
check box.
Audio
heading in the
Fec
check
rowfec
and
.
none
,
(column
colfec
48
Advertisement
Table of Contents
