Table of Contents
Advertisement
Decoder Display and Configuration Page
To access the decoder display and configuration page (see figure 35), click the display
icon on the device page.
1
2
Figure 35.
The available controls consist of two main panels:
a
b
Decoder Video Configuration Panel
Figure 36.
Ä
Å
û
ü
For each change made, click the
Decoder Display and Configuration Page
Decoder video configuration controls — Provides controls for the display name
and the splash screen display and displays the active format (see
Configuration
Panel", below).
Decoder streams configuration controls — Provides control for stream selection
(see
"Decoder Streams Configuration
statistics page.
1a
1b
Decoder Video Configuration Panel
Name field — This is the name that is displayed in the device list page. This can be
changed to any value.
Nodata splash checkbox — Enables the display of a splash screen when the display
device detects a break in the input data stream. When this control is disabled the last
decoded frame is displayed.
Genlock checkbox — Enables a a local SDI input of the same refresh rate as the
streamed video to act as a digital genlock signal for synchronizing the decoder to a local
standard.
Active format — Reports the currently selected output mode. The reported mode is the
source type. If no source is available, the splash screen resolution is reported.
Panel") and a link to the bit rate and stream
1c
1d
button to confirm the change.
Update
VN-Matrix 325 Serial Digital Over IP CODEC • Operation
"Decoder Video
47
Advertisement
Table of Contents
