Table of Contents
Advertisement
Installation and
Setup
This section details the installation and initial configuration of the VN-Matrix VNC 325
codecs, including:
•
•
•
•
•
•
•
Installation and Setup Overview
This section introduces a checklist of the actions that you should do in the order shown
to install and configure all of the VNC 325 codecs in the VNM 325 system and to start
streaming data.
NOTE:
�
�
�
�
�
�
Installation and Setup Overview
Rear Panel Features
Mounting the Units
Planning the System Architecture
Configuring Network Settings
Making Remaining Connection
Configuring Encoders and Decoders
For best results, and to avoid network disruption, install and setup the system in
the order shown below.
Familiarize yourself with the signal and power connections on the codec (see
Panel
Features").
If desired, mount the units (see
Determine the data transport method and system routing that you will use in your
system (see
"Planning the System
Use a computer connected to the Remote port on each unit to configure the network
settings for that unit. Set one encoder in the system as the controller.
See
"Configuring Network
Make all remaining connections, including LAN connections, one or more sources, and
"Making Remaining
all displays (see
Use a web browser and the network interface to configure the system for the data
transport method selected (see
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
"Mounting the
Units").
Architecture").
Settings".
Connections").
"Configuring Encoders and
"Rear
Decoders").
5
Advertisement
Table of Contents
