Table of Contents
Advertisement
j
RS-232 and IR connector — Connect a serial RS‑232 signal, a modulated IR
signal, or both to this 3.5 mm, 5‑pole captive screw connector for bidirectional RS‑232
and IR communication (see
connector).
k
Power input connector — Plug the included external 12 VDC power supply into
either this 2‑pole connector or the power input connector on the transmitter (see
f
item
connector).
NOTES:
•
•
Connector and Cable Details
TP cable termination and recommendations
Figure 5 details the TIA/EIA T 568B wiring standard. Use this standard to terminate TP
cables with RJ‑45 connectors.
Side
Figure 5.
NOTE: Do not use Extron UTP23SF‑4 Enhanced Skew‑Free AV UTP cable or STP201
cable to link the transmitter and receiver. The DTP DVI 230 Tx/Rx does not work
properly with these cables.
RS-232 and IR connector wiring
on the previous page) (see
One power supply is included with the transmitter and normally can power
both units.
If you have removed the ground jumpers (see
on page 11) because of ground potential differences, one DTP DVI 230 unit
cannot remotely power the other unit. Each unit requires a local power
supply.
Pins:
1 2 3 4 5 6 7 8
TIA/EIA T
568 B
Pin
Wire color
1
White-orange
Orange
2
3
White-green
4
Blue
5
White-blue
6
Green
Insert
7
White-brown
Twisted
8
Brown
Pair Wires
TP Cable Termination
DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation
Power supply wiring
on page 8 to wire the
Disconnecting the Ground
on page 9 to wire the
6
Advertisement
Table of Contents
