Reference Information; Mounting The Transmitter Or Receiver; Tabletop Use; Mounting Kits - Extron electronics DTP DVI 230 User Manual

Reference
Information
This section provides procedures for mounting the DTP DVI 230 Tx/Rx transmitter and
receiver and disconnecting the ground between them.
•
•

Mounting the Transmitter or Receiver

ATTENTION:
The 1‑inch high, quarter rack width DTP DVI 230 transmitter or receiver can be placed on
a table, mounted in a rack, or mounted under a desk or table. The receiver can also be
mounted on a projector bracket.

Tabletop Use

Affix the included rubber feet to the bottom of the unit and place it in any convenient
location.

Mounting kits

Mount the unit using any optional compatible mounting kit listed on the Extron website
(www.extron.com), in accordance with the directions included with the kit. For rack
mounting, see
Mounting the Transmitter or Receiver
Disconnecting the Ground
• Installation and service must be performed by authorized personnel only.
• Avoid ground potential differences between the transmitter and receiver installation
sites, which can lead to equipment damage or a missing or unstable picture. If
a potential difference cannot be avoided, remove the ground connection between
the units and locally power both units (see
next page).
UL Rack-Mounting Guidelines
DTP DVI 230 Tx/Rx Transmitter and Receiver • Reference Information
Disconnecting the Ground
on the next page.
on the
10