Table of Contents
Advertisement
Installation and
Operation
This section describes the installation and the operation of the DTP DVI 230 Tx/Rx Extender,
including:
•
•
•
Mounting the Units
Mounting instructions can be found in
page 10. Compatible optional hardware is listed on the Extron website (www.extron.com).
ATTENTION:
Connections
Transmitter Connections
DDC ROUTE
POWER
REMOTE
12V
0.8 A MAX
ON
1 2
SPARE
LOCAL
Rear
6
Figure 2.
a
Mounting the Units
Connections
Operation
•
Installation and service must be performed by authorized personnel only.
•
Avoid ground potential differences between the transmitter and receiver installation
sites, which can lead to equipment damage or a missing or unstable picture. If
a potential difference cannot be avoided, remove the ground connection between
the units and locally power both units (see
page 11). In this configuration, the DTP DVI 230 cannot extend analog audio and
each unit requires a local power supply.
OVER DTP
SIG
LINK
RS-232
IR
DTP OUT
Tx
Rx
Tx
Rx
G
5
4
DTP DVI 230 Tx Connectors
DVI input connector — Connect an DVI cable between this port and the DVI output
port (or HDMI port, with an appropriate adapter) of the digital video source.
DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation
Mounting the Transmitter or Receiver
Disconnecting the Ground
INPUTS
DVI-D
AUDIO
Front
3
1
on
on
LOCAL OUTPUT
DTP DVI 230 Tx
2
3
Advertisement
Table of Contents
