Front Panel - Extron electronics DMS 1600 Setup Manual

e
Remote port — If desired, connect a control system or computer to
the rear panel Remote RS-232/RS-422 port.
Pin
1
2
5 1
3
4
5
6
9 6
7
8
9
Figure 7. Remote RS-232/RS-422 Output Connector Wiring
f
Ethernet port (LAN connector) — If desired, connect a network
WAN or LAN hub, a control system, or a computer to the Ethernet
RJ-45 port.
Network connection — Use a patch (straight-through) cable.
Computer or control system connection — Use a crossover
cable.
The factory default IP address is 192.168.254.254.
NOTE:
g
Reset button — Initiates four levels of reset of the matrix switcher.
For different reset levels, press and hold the recessed button while
the switcher is running or while you power up the switcher.
See the DMS Series Matrix Switcher User Guide, available on the
Extron DVD or at www.extron.com.
h
Power connectors — Plug the switcher into one or two (depending
on the DMS model) grounded AC sources.
For reliability in switchers with Primary and Redundant
NOTE:
power supplies, connect the power cord from the Redundant
power connector to either an uninterruptible power source or to
a power source that is completely independent of the primary
power source.
i
Primary and Redundant power supply indicator LEDs
(DMS 1600 and DMS 3600) —
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances or has failed (see
Installing a Power Supply Module (DMS 1600 and DMS 3600)
page 31 to replace the power supply).
j
Fans (DMS 1600 and DMS 3600) — See
Installing a Fan (DMS 1600 and DMS 3600)
8 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Installation
RS-232 Function RS-422 Function
— Not used — Not used
Tx Transmit Tx– Transmit (–)
Rx Receive Rx– Receive (–)
— Not used — Not used
Gnd Ground Gnd Ground
— Not used — Not used
— Not used Rx+ Receive (+)
— Not used Tx+ Transmit (+)
— Not used — Not used
Removing and
on
Removing and
on page 32.

Front Panel

CONTROL
CONFIG
ENTER PRESET VIEW ESC
PRIMARY
REDUNDANT
POWER SUPPLY
DMS 1600
TMDS DIGITAL MATRIX SWITCHER
1 2
Figure 8. Front Panel Features
a
Configuration port — If desired, connect a control system or
computer to the front panel Configuration port, a mini USB B port
b
Primary and Redundant Power Supply LEDs
(DMS 1600 and DMS 3600) —
NOTE: The meaning of these indicators is identical to the LEDs
on the power supplies
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances or has failed (see
Installing a Power Supply Module (DMS 1600 and DMS 3600)
page 31 to replace the power supply).
c
Power LED (DMS 2000 and DMS 3200)— Indicates that the
power supply is operating within normal tolerances.
NOTE: The power supply is fixed, and not field replaceable, on
the DMS 2000 and DMS 3200.
DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Installation
CONTROL
VIEW ESC
CONFIG ENTER PRESET
POWER
DMS 2000
TMDS DIGITAL MATRIX SWITCHER
1 3
.
i
(item , on the previous page).
Removing and
on
9