Lenovo ThinkServer TD340 User Manual And Hardware Maintenance Manual page 150

8. Install the new non-hot-swap hard disk drive into a blue bracket by flexing the sides of the bracket and
aligning pin 1 , pin
drive so that the hard disk drive can be seated in the bracket.
Note: Do not touch the circuit board
Figure 75. Installing the non-hot-swap hard disk drive into the bracket
9. Slide the new non-hot-swap hard disk drive with bracket into the drive bay until it snaps into position.
10. Connect the appropriate power cable
hard disk drive. See "Connecting the cables" on page 43.
Figure 76. Connecting cables to the rear of the non-hot-swap hard disk drive
11. Connect the other end of the SATA signal cable to the appropriate SATA connector on the system board.
See "System board components" on page 48 and "Connecting the cables" on page 43.
12. Reinstall the front system fan 1. See "Replacing the front system fan 1" on page 183.
138
ThinkServer TD340 User Guide and Hardware Maintenance Manual
2 , pin 4 , and pin 5 on the bracket with the corresponding holes in the hard disk
3 on the bottom of the hard disk drive.
1 and the SATA signal cable 2 to the rear of the non-hot-swap