Chassis-3 - Cisco Catalyst 4500 Series Message Manual

CHASSIS Messages
Error Message C4K_CHASSIS-2-INSUFFICIENTFANSSHUTDOWN: Resetting linecards due to fan
tray failure
Error Message C4K_CHASSIS-2-INSUFFICIENTPOWERDETECTED:Insufficient power available
for the current chassis configuration
Error Message C4K_CHASSIS-2-INSUFFICIENTPOWERSHUTDOWN:Holding module in slot [dec]
in reset, due to insufficient power
Error Message C4K_CHASSIS-2-OVERHEATINGSHUTDOWN:Resetting linecards due to critical
temperature

CHASSIS-3

Error Message C4K_CHASSIS-3-BADMACRANGEINSPROM:Module [dec]'s serial eeprom
contains [dec] mac addresses, but needs [dec]
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-4
One or more required fans in the fan tray or the power supplies is malfunctioning.
Explanation
Software reset the modules to reduce heat generation.
Replace the broken fans as soon as possible.
Recommended Action
Explanation The current chassis configuration exceeds power availability. If this condition persists,
software will reset the modules.
If the power availability problem persists and impacts performance, replace the
Recommended Action
power supply with a larger capacity power supply.
The switch was using more power than is available for the allowed time interval.
Explanation
Software reset the modules to reduce power consumption.
If the power availability problem persists and impacts performance, replace the
Recommended Action
power supply with a power supply with a larger capacity.
The switch is now warmer than its maximum allowable operating temperature. Software
Explanation
will reset modules to reduce heat generation.
Verify that the switch is in the proper operating environment and that the fans
Recommended Action
are functioning properly.
The contents of the module's serial EEPROM is incorrect, and the range is smaller than
Explanation
the number of front-panel ports for the module. The module's serial EEPROM contains a range of
MAC addresses for this module, and the range should contain the same number of MAC addresses
as the number of front-panel ports because each MAC address corresponds to a front-panel port.
Contact your technical support representative; you will likely have to return the
Recommended Action
module to Cisco to reprogram the serial EEPROM.
Chapter 2 Messages and Recovery Procedures
OL-11541-01