Acl Messages; Arp Snooping Messages; Buffermanager Messages - Cisco Catalyst 4500 Series Message Manual

ACL Messages

ACL Messages
This section contains the access control list (ACL) message.
Error Message C4K_ACL-4-OUTOFMEMORY:Out of Memory while allocating [char]

ARP Snooping Messages

This section contains the ARP snooping message.
Error Message C4K_ARPSNOOPINGMAN-4-OUTOFRESOURCES: Resources for constructing ACLs
are not available.

BUFFERMANAGER Messages

This section contains the memory buffer management (BUFFERMANAGER) message.
Error Message C4K_BUFFERMANAGER-3-OUTOFVBUFS: Have run out of vbufs (internal
buffers)
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-2
Explanation The software failed to allocate memory for the given object while processing ACLs. The
configuration might have exceeded its maximum limit. If so, the feature using this ACL will not
work.
Recommended Action If it is mandatory that the feature work normally, remove other unwanted
features that require ACLs and retry the operation. If the problem persists, contact your technical
support representative.
Software resources are not available to setup hardware to redirect ARP packets to
Explanation
software. Dynamic ARP inspection will not work if this log message appears.
Unconfigure other TCAM related features to reduce switch memory
Recommended Action
requirements and reconfigure the ACL.
Explanation The switch ran out of the internal memory buffers that are used for various tasks. This
error is unusual because the internal buffers are used for only a short time, released, and then
available for reuse. Typically, this condition is transitory.
If the message persists, reboot the switch.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11541-01