Commonstubman Messages; C4K_Commonstubman-4 - Cisco Catalyst 4500 Series Message Manual

COMMONSTUBMAN Messages

Error Message C4K_COMMONHWACLMAN-4-PORTBASEDACLSDISABLED: Output Port Acl
has been disabled on port
Error Message C4K_COMMONHWACLMAN-4-PUNTTOSOFTWARE:Out of resources, punt packets to
sw for [object-info]
COMMONSTUBMAN Messages
This section contains the Catalyst 4500 series ASIC-specific messages.

C4K_COMMONSTUBMAN-4

Error Message C4K_COMMONSTUBMAN-4-DIAGSFAILED: [char] failed diagnostics
Error Message C4K_COMMONSTUBMAN-4-FAILEDTOSENDLOOPBACKTRIES: [char] port [dec]
failed to send packet in [dec] tries
Error Message C4K_COMMONSTUBMAN-4-UNEXPECTEDLOOPBACK: [char] sent out a loopback
packet on port [dec], but it came back on port [dec]
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-14
The output port ACL is disabled on the interface because there are not enough hardware
Explanation
resources or there are ACEs that require CPU processing of packets.
The port ACL is disabled and displays a warning message because the software cannot handle the
output port ACLs.
This is an informational message only. No action is required.
Recommended Action
Explanation The hardware content-addressable memory (CAM) resources have been depleted. The
hardware forwards the packets to the software for ACL processing.
Remove unnecessary ACLs from some interfaces.
Recommended Action
An ASIC in slot [char] failed diagnostics.
Explanation
Recommended Action Contact your technical support representative.
An ASIC in slot [char] was unable to send a loopback packet on port [dec] and this is
Explanation
the [dec]th time it tried to send and failed. This suggests that the switch is out of memory. The
software will attempt to send a loopback packet only three times.
Contact your technical support representative.
Recommended Action
The ASIC diagnostics for slot [char] sent a loopback packet out port [dec] and it came
Explanation
back on another port [dec]. This is unexpected because the loopback is done within the hardware.
Contact your technical support representative.
Recommended Action
[char]
Chapter 2 Messages and Recovery Procedures
[char]
OL-11541-01