Swnetflowman-6; Sysman Messages; Sysman-2 - Cisco Catalyst 4500 Series Message Manual

SYSMAN Messages

Error Message C4K_SWNETFLOWMAN-4-NETFLOWCACHEFULL: Netflow hardware-software map
cache full. Could not create a map.

SWNETFLOWMAN-6

Error Message C4K_SWNETFLOWMAN-6-FIXEDCREATIONTIME:Fixed creation time of
flows.
SYSMAN Messages
This section contains the System Manager (SYSMAN) messages.

SYSMAN-2

Error Message C4K_SYSMAN-2-POWERONSELFTESTFAIL:Supervisor module in slot [dec]
failed Power-On-Self-Test(POST). Line cards are **NOT** initialized. Please use
'show diagnostics result module [dec]test <tid> detail' command for details.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-118
The switch uses a map to correlate flow in the software with corresponding flows in the
Explanation
hardware. This map is full and the switch cannot create any more mappings. This is a very rare
condition. The switch is running at full capacity.
This is an informational message only. No action is required.
Recommended Action
The system did not record the creation time of a flow. In this case, the system
Explanation
determined a creation time, which is usually the same time that was used for the last flow.
Recommended Action If this message reoccurs frequently, and you see that the system is fixing a lot
of flows, contact your technical support representative.
A power-on self test (POST) failure is detected on the supervisor engine. When this
Explanation
occurs, the modules are not initialized.
Use the show diagnostics result module dec test tid detail command to
Recommended Action
isolate the problem. Reset the switch after you have resolved the supervisor engine failure.
Chapter 2 Messages and Recovery Procedures
[dec]
OL-11541-01