Chapter 2
Messages and Recovery Procedures
PORTFANOUTASIC8X100MAN-7
Error Message C4K_PORTFANOUTASIC8X100MAN-7-LOSTPACKET:[char] port [dec] lost a
packet
QOS Messages
This section contains the quality of service (QOS) message.
Error Message C4K_QOS-4-OUTOFPOLICERRESOURCES:Out of memory to allocate a policer
REDUNDANCY Messages
This section contains the supervisor engine redundancy (REDUNDANCY) messages.
REDUNDANCY-2
Error Message C4K_REDUNDANCY-2-HANDSHAKE_TIMEOUT_ACTIVE: The handshake messaging
between active and standby has not yet started.
OL-11541-01
A loopback packet was lost during online diagnostics of this port.
Explanation
This is an informational message only. No action is required.
Recommended Action
The software failed to allocate memory for a policer while processing the QoS
Explanation
configuration, possibly because the policer configuration exceeded its maximum supported limit.
Remove policers from other unwanted policies, and retry the operation. Resend
Recommended Action
the command when other Telnet sessions are not sending debugging commands.
The initial handshake message exchange between active and standby supervisor engines
Explanation
has not yet started. Traffic on the active supervisor engine is not affected, but supervisor engine
redundancy will not work.
Please schedule a downtime ASAP and reset the active supervisor engine.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
QOS Messages
2-81