Iprouteman-4 - Cisco Catalyst 4500 Series Message Manual

Cisco ios system message guide
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

IPROUTEMAN Messages
Error Message C4K_IPROUTEMAN-3-VRFMANDUPLICATEVRF: Tried to create a duplicate VRF
for key
Error Message C4K_IPROUTEMAN-3-VRFMANNONEXISTENTDELETION: Attempted to delete VRF
with key
Error Message C4K_IPROUTEMAN-3-WCCPMALLOCFAILURE: WCCP service group [char]
not be setup

IPROUTEMAN-4

Error Message C4K_IPROUTEMAN-4-CANTALLOCATEFIBENTRY: FIB: No memory available to
allocate FIB Entry
Error Message C4K_IPROUTEMAN-4-VRFMANCANTALLOCATEVRF: No memory available to
allocate VRF for key
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-62
[object-info]
A request was made to add a duplicate VRF.
Explanation
Recommended Action
This is an informational message only. No action is required.
[object-info] which does not exist
A request was made to delete a VRF that does not exist.
Explanation
This is an informational message only. No action is required.
Recommended Action
for redirection due to memory allocation failure.
The service group cannot be set up for redirection in hardware because of failure to
Explanation
allocate memory. The traffic that is expected to be redirected by this service group will be routed
normally. This condition might occur under extreme ACL, QoS, PBR, VRF, or other L2/L3 feature
configurations.
Try removing the unused or unneeded configuration on the switch before
Recommended Action
attempting to configure the service group again. Please note that even though the service group
configuration shows up in the CLI, it has failed to be set up in hardware. Therefore, the service group
should be unconfigured before configuring it again. If the above does not help, please contact Cisco
Technical Assistance for further troubleshooting and resolution of the problem.
Explanation
The switch has insufficient memory to allocate space for the route that is associated with
this network.
Install additional memory.
Recommended Action
[object-info]
The switch has insufficient memory to allocate space for VRF.
Explanation
Recommended Action
Install additional memory.
Chapter 2
Messages and Recovery Procedures
could
OL-11541-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents