Hw Messages - Cisco Catalyst 4500 Series Message Manual

HW Messages

Error Message C4K_FLASH-4-COMPACTFLASHNOTREADY: Compact flash is not ready
HW Messages
This section contains the hardware (HW) messages.
Error Message C4K_HW-3-S2WERROR:[char] [char] [dec] Error: [object-info] Device
Addr: [dec] Mem Addr: [object-info] Value: [dec]
Error Message C4K_HW-3-X2IDENTIFICATIONFAILURE:Error while trying to identify serdes
type for
Error Message C4K_HW-3-X2OUIREGREADFAILURE:Error while reading Supervisor X2 OUI
register Device Addr: [dec]
Error Message C4K_HW-3-X2LOOPBACKFAILURE: Failed to put [char] Xaui([dec]) [char]
loopback
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-34
You may see this message if the compact flash is not inserted properly or if it is removed
Explanation
while the switch is trying to access the flash.
Reinsert the compact flash and retry the operation.
Recommended Action
An unexpected error occurred when the switch accessed the hardware device specified
Explanation
in the message.
Contact your technical support representative.
Recommended Action
[char] ( [dec]
There was an error when trying to identify the X2 module type.
Explanation
Recommended Action Contact your technical support representative. You will probably need to
replace the supervisor engine.
Explanation There was an unexpected error when accessing a hardware device with the given device
address.
Contact your technical support representative. You will probably need to
Recommended Action
replace the supervisor engine.
Software was unable to put the X2 in or out of loopback because it was unable to
Explanation
determine the X2 type.
This is an informational message only. No action is required.
Recommended Action
) X2 module
Chapter 2 Messages and Recovery Procedures
OL-11541-01