Cache Mode Control (J3); Flash Bank Selection (J10) - Motorola MVME2600 series Installation And Use Manual

Cache Mode Control (J3)

256KB of L2 cache memory is available on the MVME2603/2604. L2
cache operation is transparent to users, but its write-through mode is
configurable via header J3 on older boards. On newer MVME2603/2604
boards, header J3 is not provided. With a jumper installed on J3, cache
write-through is under CPU control. With the jumper removed, cache
write-through occurs in all cases.
Cache Write-Through under CPU Control

Flash Bank Selection (J10)

The MVME2603/2604 base board has provision for 1MB of 16-bit Flash
memory. The RAM200 memory mezzanine accommodates 4MB or 8MB
of additional 64-bit Flash memory.
The Flash memory is organized in either one or two banks, each bank
either 16- or 64-bits wide. Both banks contain the onboard debugger,
PPCBug.
To enable Flash bank A (4MB or 8MB of firmware resident on soldered-
in devices on the RAM200 mezzanine), place a jumper across header J10
pins 1 and 2. To enable Flash bank B (1MB of firmware located in sockets
on the base board), place a jumper across header J10 pins 2 and 3.
Flash Bank A Enabled (4MB/8MB, Soldered)
(factory configuration)
http://www.motorola.com/computer/literature
J3
2 1
J10
3
2
1
MVME2603/2604 Base Board Preparation
J3
2
Cache Write-Through Always
(factory configuration)
J10
3
2
1
Flash Bank B Enabled (1MB, Sockets)
1
1-7
1