Troubleshooting; Please Read The Following Carefully - Chicago Electric 97588 Set Up And Operating Instructions Manual

problem
Tool will not start 1.
2.
3.
Tool operates 1.
slowly or
erratically.
2.
Tool does not 1.
grind, sand or
brush effectively.
2.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.

please reaD tHe FOllOWing careFully

THE MANUfACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAGRAM IN THIS MANUAL AS A REfERENCE TOOL ONLy. NEITHER THE MANUfACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIfIED TO MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIfIED TO REPLACE ANy PARTS Of THE PRODUCT. IN fACT, THE MANUfACTURER AND/
OR DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAkEN By CERTIfIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE
BUyER ASSUMES ALL RISk AND LIABILITy ARISING OUT Of HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT Of HIS OR HER
INSTALLATION Of REPLACEMENT PARTS THERETO.
SKU 97588

troubleshooting

possible causes
No power at outlet.
Cord not connected.
Carbon Brushes may be worn or
damaged.
Carbon Brushes may be worn or
damaged.
Excess pressure applied to
workpiece.
Disc accessory may be loose on
Spindle. Check tightness of Outer
Flange Arbor Nut or threaded disc
accessory on Spindle.
Disc accessory may be damaged,
worn or wrong type for the
material.
For technical questions, please call 1-800-444-3353.
likely solutions
1. Check power at outlet.
2. Check that cord is plugged in.
3. Inspect Carbon Brushes and replace if
necessary.
1. Inspect Carbon Brushes and replace if
necessary.
2. Decrease pressure, allow tool to do
the work.
1. Be sure disc accessory is of correct
dimension and Outer Flange Arbor Nut
is tight.
2. Check condition and type of disc
accessory. Use only proper type of
disc accessory in good condition.
Page 18