Table of Contents
Advertisement
problem
Tool will not start
1.
2.
Tool operates
1.
slowly or
erratically.
2.
Tool does not grind
1.
effectively.
2.
Follow all safety precautions whenever diagnosing or servicing the
tool. disconnect power supply before service.
pLeASe reAd THe FOLLOWing cAreFuLLY
THE MANufACTurEr AND/or DiSTribuTor HAS ProviDED THE PArTS LiST AND ASSEMbLy
DiAgrAM iN THiS MANuAL AS A rEfErENCE TooL oNLy. NEiTHEr THE MANufACTurEr or
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE or SHE iS quALifiED To MAKE ANy rEPAirS To THE ProDuCT, or THAT HE or SHE iS
quALifiED To rEPLACE ANy PArTS of THE ProDuCT. iN fACT, THE MANufACTurEr AND/
or DiSTribuTor ExPrESSLy STATES THAT ALL rEPAirS AND PArTS rEPLACEMENTS SHouLD
bE uNDErTAKEN by CErTifiED AND LiCENSED TECHNiCiANS, AND NoT by THE buyEr. THE
buyEr ASSuMES ALL riSK AND LiAbiLiTy AriSiNg ouT of HiS or HEr rEPAirS To THE
origiNAL ProDuCT or rEPLACEMENT PArTS THErETo, or AriSiNg ouT of HiS or HEr
iNSTALLATioN of rEPLACEMENT PArTS THErETo.
SKU 99675
Troubleshooting
possible causes
Battery discharged.
Carbon brushes worn or damaged.
Carbon Brushes worn or damaged.
Excess pressure applied to
workpiece.
Disc accessory loose on Spindle.
Disc accessory damaged, worn or
wrong type for material.
For technical questions, please call 1-800-444-3353.
Likely Solutions
1.
Charge battery.
2.
Have a qualified technician replace
carbon brushes.
1.
Have a qualified technician replace
carbon brushes
2.
Decrease pressure, allow tool to do
the work.
1.
Be sure disc is correct dimension and
Clamp Nut tight.
2.
Use correct disc accessory in good
condition.
Page 12
Advertisement
Table of Contents
