Specifications; Instructions For Putting Into Use; List Of Contents; Safety Information - Chicago Electric 97588 Set Up And Operating Instructions Manual

speciFicatiOns

Electrical Requirements
Motor No Load Speed
Wheel Diameter
Arbor Diameter
Spindle Thread
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.

list of contents

Description
Angle Grinder
Grinding Wheel
Quick Release Wheel Guard
Auxiliary Handle
Pin Wrench
Owner's Manual
instructiOns FOr
putting intO use
read the entire iMpOrtant

saFety inFOrMatiOn

section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
SKU 97588
120 V~ / 60 Hz / 15 A
8000 RPM
7 inches
7/8 inch
5/8 inch x 11 TPI
90sM
e194601
Q'ty
1
1
1
1
1
1
For technical questions, please call 1-800-444-3353.
FrOM acciDental
OperatiOn:
turn the power switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
installing the Wheel guard
1. The Wheel Guard (7) must be in-
stalled before installing a grinding
wheel or other disc.
2. Loosen the Wheel Guard Quick Re-
lease (6) by pulling the lever outward.
3. Slide the collar of the Wheel Guard
(7) over the rim of the Front Cap (13).
4. Rotate the position of the Wheel
Guard as needed for the planned
work.
5. Tighten the Wheel Guard Quick Re-
lease by pressing the lever back in
place. The clamping pressure of the
Quick Release may be adjusted us-
ing the Nut (4).
6. Check the Wheel Guard to ensure it
is firmly in place. Adjust if necessary
before proceeding.
tO prevent
seriOus injury
Page 12