Chapter 3 Setup Procedures; Configuring The Ice Terminal - Hypercom ICE 5000 Hardware And Installation Operators Manual

C h a p t e r
Setup Procedures
This chapter provides setup procedures for the Hypercom ICE 5000 and 5500 terminal, including the
steps necessary for terminal configuration, program load, and initialization. Please refer to the ICE
5000 PIN Pad Loader Operators Manual when configuring a terminal for Debit Processing.

Configuring the ICE Terminal

A configuration sets the parameters the ICE 5000 or 5500 uses to communicate with Term-Master.
When the configuration is complete, the terminal is able to receive the terminal application software.
Step-by-Step
To configure the ICE terminal:
Step Action
The Idle prompt appears.
1 Touch 1 on the terminal display.
3
Terminal response
CONFIGURE TERMINAL
OR CALL HELP - PE
0: RESTART
1: MERCHANT PROGRAMMING
2: PROGRAM LOAD
3: CLEAR PAGE MEMORY
4: MAINTENANCE FUNCTIONS
5: FAST LOAD
MERCHANT PROGRAMMING
TERMINAL ID NUMBER
XXXXXXXXX
Q W E R T Y U I O P
A S D F G H J K L
ÏZ X C V B N M SPACE
CANCEL CLEAR ENTER