Motorola DCT6400 Series Installation Manual page 48

High definition dual-tuner dvr cable receiver
Hide thumbs Also See for DCT6400 Series:
Table of Contents

Advertisement

Field
Hard Drive Status
Smart Card
DVI Port
Device Connected
Repeater
Video Xmission
(transmission)
HDCP Enabled
Video Constrained
Output Format
Aspect Ratio
EDID Data
Description
INST (installed) or NOT INST (not installed)
INST (installed) or NOT INST (not installed)
If a device is connected to the DVI port only, the following diagnostics display to help
troubleshoot problems with the DVI interface. They all display "N/A" if no device is
connected to the DVI port or the value is invalid or cannot be retrieved.
Indicates whether a device is connected to the set-top — Yes or No.
Indicates whether the connected device is a repeater — Yes or No.
Indicates whether the set-top is transmitting video over the DVI port — Not Active or
Active.
Indicates whether the set-top is using HDCP to encrypt video transmitted over the
DVI link — Yes or No.
If the Video Xmission status is Not Active, the HDCP Enabled status is No.
Indicates whether the set-top is constraining the video sent through DVI — Yes or
No.
If the Video Xmission status is Not Active, the Video Constrained status is No.
Indicates the timing format of the video sent through DVI:
1920 x 1080I — 1920 pixels wide by 1080 pixels high, interlaced
1280 x 720P — 1280 pixels wide by 720 pixels high, progressive
720 x 480P — 720 pixels wide by 480 pixels high, progressive
720 x 480I — 720 pixels wide by 480 pixels high, interlaced
640 x 480P — 640 pixels wide by 480 pixels high, progressive
Indicates the aspect ratio of the video sent through DVI — 3:4 or 16:9.
Indicates the video timing formats that were read from the Extended Display
Identification Data (EDID) registers for the connected device, in particular the
detailed timing description blocks. The list displays all of the formats that the set-top
could read up to a maximum of 12 formats. If the set-top cannot read any formats,
EDID Data is blank. An asterisk (*) after the aspect ratio means the set-top supports
the format. If more than twelve video timing formats are discovered, the supported
formats only are listed first followed by any remaining formats, up to twelve.
Diagnostics
DCT6400 Series Installation Manual
4-17

Advertisement

Table of Contents
loading

Table of Contents