troubleshooting
76
troubleshooting
In most cases you will be able to identify and remedy faults by checking the following.
check if:
the upper and lower threads are threaded correctly
█
the needle is inserted correctly
█
the needle size is correct - check the needle/thread table page 24
█
the needle tip and shaft are undamaged
█
the sewing computer is clean - brush out any thread lint
█
the hook race is clean
█
any threads are trapped between the tension discs or under the bobbin case spring
█
fault
cause
uneven stitch
̶ Upper thread too tight/too slack
formation
̶ Needle blunt or bent
̶ Poor quality needle
̶ Poor quality thread
̶ Needle/thread combination is incorrect
̶ Incorrectly threaded
Skipped stitches
̶ Incorrect needle system
̶ Needle bent or blunt
̶ Poor quality needle
̶ Needle inserted incorrectly
̶ Incorrect needle point
faulty stitching
̶ Remnants of thread between the
̶ Incorrectly threaded
̶ Remnants of thread under the bobbin
thread is caught
̶ Upper thread breaks
in the area of the
take-up lever
upper thread
̶ Upper thread tension too tight
breaks
̶ Incorrectly threaded
̶ Poor-quality or old thread
̶ Stitch plate or hook tip damaged
tension discs
case spring
a
033471.52.04_2014-02_Manual_B530_550_EN
repair
reduce/increase upper thread tension
█
use new BERNINA quality needles
█
use new BERNINA quality needles
█
use quality thread (Isacord, Mettler, Gütermann etc.)
█
match the needle to the thread size
█
check upper and lower thread
█
use needle system 130/705H
█
use new BERNINA quality needles
█
use new BERNINA quality needles
█
insert needle as far up as it will go
█
match the needle point to the texture of the fabric
█
fold a piece of thin material and slide the folded edge (not the
█
raw edges) between the thread tension discs, moving the
fabric back and forth to clean the right and left side of the
thread tension
check upper and lower thread
█
carefully remove any thread remnants from under the spring
█
If the upper thread breaks and the thread is trapped in the area
of the take-up lever, proceed as follows:
power switch to «0» (off)
█
remove the screw a on the headframe with the angular Torx
█
button
turn headframe cover slightly to the left, then slide it upwards
█
and remove
remove remnants of thread
█
attach headframe and retighten screw
█
reduce upper thread tension
█
check upper thread
█
use quality threads (Isacord, Mettler, Gütermann)
█
take the sewing computer to the nearest authorized
█
BERNINA dealer