Bernina 530 User Manual page 68

For an even sewing start (the first stitch) the foot control must be
pressed and the fabric moved simultaneously. This also applies for
sewing points and straight stitching within a round form.
When resuming work with the BSR presser foot after exiting the
function, the BSR mode that was active at the time of exiting the
BSR function will be activated, even if the sewing computer was
turned off in the meantime.
When exeeding a certain speed, adhering to regular stitch length
cannot be guaranteed.
Make sure that the lens on the bottom of the BSR foot is clean (no
fingerprints, etc.). Clean lens periodically with soft, slightly damp
cloth.
preparation
lower the feed dog
█
presser foot pressure may be reduced depending on the material type and
█
thickness
use slide-on table
█
use the Free Hand System
█
removing the presser foot sole
press both buttons together
█
slide the sole downwards out of the groove
█
attaching the presser foot sole
slide the desired sole up in the groove until it clicks into its place
█
attach the BSR presser foot to the sewing computer
█
plug the cable in the outlet provided
█
►
BSR-Display is opened automatically
►
straight stitch is activated
►
BSR 1 mode is engaged
select the zig-zag or the straight stitch again by pressing the «Direct
█
Selection»-button
set the desired stitch length
█
̶ the basic stitch length is 2 mm
̶ when sewing small forms and stipplings, stitch length of 1-1.5 mm is
suggested
033471.52.04_2014-02_Manual_B530_550_EN
BSr
67