Blind hem
Wrong side of
the material
Right side of the material
Hem visible
Blindstitch foot/sole no. 5
Blindstitch no. 9
For invisible hems in medium to heavy cotton, wool and blended materials.
preparation
finish raw edges
█
fold and baste or pin the hem
█
fold the fabric back over the right side of the fabric to expose the finsihed
█
lower edge
place under presser foot and
█
move the folded edge against the metal guide on the presser foot
█
Sewing
̶ the metal guide on the sole of the blindstitch sole can be adjusted sideways
by turning the screw on the right
̶ the needle should just pierce the edge of the fold (as when hand blind-
stitching)
after sewing about 10cm, check both sides of fabric and adjust width again
█
if necessary
fine stitch width adjustment
Guide the folded edge evenly along the metal guide on the foot =
even depth.
Guide the raw edge along the guide on the foot to keep the stitch
depth even.
reverse pattern foot/sole no. 1
Jersey stitch no. 14
For visible, elastic hems in jersey, cotton, synthetic and mixed fibers.
preparation
iron the hem, baste if necessary
█
reduce the presser foot pressure if necessary
█
Sewing
sew the hem at preferred depth on the right side
█
trim excess fabric from the wrong side
█
033471.52.04_2014-02_Manual_B530_550_EN
practical stitches
47