Sewing preparation
16
threading the upper thread
a
B
D
e
c
f
changing the needle
raise the needle and presser foot
█
turn power switch to «0» (off)
█
place foam pad on pin base
█
place spool on pin so that the thread unwinds clockwise
█
attach appropriate spool disc
█
take thread through rear guide a
█
then into slit of upper thread tension B
█
pull thread down to the right of the take-up cover and around c
█
take thread up to the left of the cover and around D, placing it in the
█
take-up lever
take thread down and through guides e and f
█
thread the needle (see page 18)
█
appropriate spool disc
Diameter of thread spool determines disc size, there must be no gap
between the disc and the spool.
c
e
f
removing the needle
raise needle
█
lower or remove presser foot (see page 12)
█
turn power switch to «0» (off)
█
loosen the needle clamp screw
█
pull the needle down to remove
█
Inserting the needle
flat side of needle to the back
█
insert the needle as far as it will go
█
tighten the needle clamp screw
█
033471.52.04_2014-02_Manual_B530_550_EN