Event Notification Response - Promise VTRAK M610i Product Manual

Event Notification Response

When you select Event Notification, WebPAM PROe sends popup and/or email
messages regarding its status. The messages you see depend on your
notification selection and what is currently happening in the VTrak. See "Setting-
up User Event Subscriptions" on page 58.
The table below cites:
• Reported Events – Events that require you to take action
• Corrective Actions – The action you should take in response to the event
A list of event categories is shown below.
• Battery (page 255)
• Blowers (page 256)
• Cache (page 257)
• Controller (page 257)
• Disk Array (page 257)
• Drive Interface Controller
(page 258)
• Enclosure (page 258)
• Event Log (page 258)
• Host Interface Controller
(page 258)
• iSCSI (page 259)
• Logical Drive (page 259)
• Media Patrol (page 260)
• Online Capacity Expansion
(page 261)
• PDM (page 261)
Reported Event
Battery
Battery temperature is
above the threshold
Battery temperature is
normal
Battery capacity is below
the threshold
• Physical Disk (page 262)
• PSU (Power Supply Units)
(page 263)
• PSU Fans (page 264)
• RAID Level Migration (page 264)
• Rebuild (page 265)
• Redundancy Check (page 265)
• Resource (page 266)
• Spare Check (page 266)
• Spare Drives (page 266)
• SMART (page 267)
• Stripe Level Migration (page 267)
• Synchronization (page 267)
• System (VTrak) (page 268)
• Transition (page 268)
• Watermark (page 268)
The battery is too hot. Verify proper airflow around
the through the VTrak. If airflow is OK, replace the
battery. See page 211.
Normal.
Battery is drained. Run battery reconditioning. See
page 98.
255
Chapter 8: Troubleshooting
Corrective Action