Firmware Upgrade Mode - ATEN CL3000 User Manual

CL3000 User Manual

Firmware Upgrade Mode

The CL3000's firmware upgrade mode can be accessed one of two ways: by
entering a hotkey sequence (see Hotkeys, page 19), or by placing the CL3000
in firmware upgrade recovery mode (see Firmware Upgrade Recovery,
page 26).
Note: In order to activate the Firmware Upgrade Mode using a hotkey
sequence, the Firmware Upgrade Recovery Switch (see page 6) must be
set to the Normal position.
1. Turn off the power to the CL3000 using the power switch located on the
back side of the console.
2. Slide the firmware switch to NORMAL (see page 6).
3. Turn on the power to the CL3000 using the power switch located on the
back side of the console.
When the CL3000 is in Firmware Upgrade Mode, the Num Lock, Caps Lock
and Scroll Lock LEDs will continually flash on and off.
To exit the Firmware Upgrade Mode, see Exiting Firmware Upgrade Mode,
page 26.
22