Firmware Upgrade Mode - ATEN CL6700MW User Manual

CL6700MW User Manual

Firmware Upgrade Mode

The CL6700MW's firmware upgrade mode can be accessed one of two ways:
by entering a hotkey sequence (see Hotkeys, page 19), or by placing the
CL6700MW in firmware upgrade recovery mode (see Firmware Upgrade
Recovery, page 27).
Note: In order to activate the Firmware Upgrade Mode using a hotkey
sequence, the Firmware Upgrade Recovery Switch (see page 6) must be
set to the Normal position.
1. Turn off the power to the CL6700MW using the power switch located on
the back side of the console.
2. Slide the firmware switch to RECOVER (see page 6).
3. Turn on the power to the CL6700MW using the power switch located on
the back side of the console.
When the CL6700MW is in Firmware Upgrade Mode, the Num Lock, Caps
Lock and Scroll Lock LEDs will continually flash on and off.
To exit the Firmware Upgrade Mode, see Exiting Firmware Upgrade Mode,
page 27.
22