HP C737990900 Technical Reference Manual page 56

Ultrium drives generation 2 scsi and fc drives volume 3: the scsi interface
Table of Contents

Advertisement

Hold
ReTen
Load
56
Commands
0 A normal load/unload will be performed.
1 A load will cause the cartridge to be pulled in and seated in the drive, but the tape will
not be threaded.
An unload will cause the tape to be unthreaded, but the cartridge will not be ejected.
In Hold position, the Cartridge Memory is accessible.
This field is ignored.
0 The drive performs an unload operation.
1 The drive performs a load operation.
Load/Unload Specific Status:
Following a successful
initiators other than the initiator of the
UNIT ATTENTION
transition). There is an exception to this: if a load occurs when the tape is
already loaded, no
Once
UNIT ATTENTION
key will be
NO SENSE
If an unformatted tape is inserted, the drive loads it and it behaves as if it is a
blank tape.
If a cartridge with no Cartridge Memory or a failed Cartridge Memory is
loaded,
CHECK CONDITION
with additional sense of 5200h (cartridge fault).
Loading a Cartridge
The drive loads a tape automatically when it is inserted, without any host
interaction. If the load is successful, media access commands are permissible
(see the Media Access check).
If the tape is already loaded when a Load request is received, the tape is
positioned at the beginning of the tape (as though a
Unlike a "full" load,
ready to ready transition) is not generated for other hosts.
If the tape is in the process of being loaded when the Load request is received,
the drive will wait for the load to complete and, assuming the load was
successful, take one of the following actions:
If the Load was issued by the current host (that is, a previous immediate-
reported load) and completed successfully,
further action is taken.
command,
LOAD
, with additional sense of 2800h (not ready to ready
sense is generated.
UNIT ATTENTION
is cleared, unsolicited positional sense is set. The sense
with additional sense of 0004h (BOT detected).
is returned with a sense key of
UNIT ATTENTION
CHECK CONDITION
command. The sense key is set to
LOAD
REWIND
with additional sense of 2800h (not
status is reported. No
GOOD
is posted to all
,
MEDIUM ERROR
had been sent).

Advertisement

Table of Contents
loading

Table of Contents