Table of Contents
Advertisement
0 The target does not use the precise delivery function and ignores the contents of the CRN field
EPDC
in the Fibre Channel Extended Link Service FCP_CNTL. HP Ultrium drives support this feature
by default.
1 The logical unit uses the precise delivery function defined in the FCP-2 standard. It makes use
of the CRN field.
Fibre Channel Port Control Mode Page
0
PS (0)
1
2
3
Rsvd (0)
4–5
6
7
Prevent Loop Port Bypass
PLPB
0 The target allows the Loop Port Bypass (LPB) and Loop Port Enable (PBE) primitive sequences
to control the port bypass circuit.
1 The target ignores any Loop Port Bypass (LPB) and Loop Port Enable (LPE) primitive
sequences. The loop port remains enabled.
Disable Discovery
DDIS
0 The target must wait to receive an Address Discovery Link Service (ADISC) or Port Discovery
Link Service (PDISC) before it resumes processing tasks for the initiator.
1 The target does not require receipt of address or Port Discovery following loop initialization.
It resumes processing of tasks on completion of loop initialization.
This page is supported for Fibre Channel only:
7
6
5
Rsvd (0)
PLPB[0]
DDIS[0]
Reserved (0)
Resource Recovery Time-Out Value
The Fibre Channel Port Control Page allows you to set the initialization and
addressing behavior of the Fibre Channel interface.
4
3
2
Page Code {19h}
Page Length {06h)
Reserved (0)
DLM[1]
RHA[0]
ALWLI[0]
Reserved (0)
1
0
DTIPE[0] DTOLI[0]
RR TOV Unit (3)
Commands
87
Advertisement
Table of Contents
