HP C737990900 Technical Reference Manual page 130

Valid
70h Indicates that the error is current, that is, it is associated with the command for which
Error Code
71h Indicates that the error is deferred. A deferred error occurs when there is a failure for
Segment Number This field is cleared to zero.
Mark
EOM
ILI
Sense Key See "Sense Keys" on
The Information Bytes field is only valid if the Valid bit is set. It contains residue information
Information Bytes
following the failure of either a
can take a negative value, expressed in twos complement notation. See the description of the
command that failed for the contents of the field.
0Eh Specifies the number of additional sense bytes to follow and is always set to 0Eh. It is
Additional Sense
Length
Command Specific
Information Bytes
Additional Sense These two bytes provide additional information about the cause of the
Code and Qualifier the current tape position when the
Codes" on
SKSV
130 Commands
Returned Sense Data Fields:
1 Indicates that the information bytes contain valid information as defined in the SCSI
specification.
CHECK CONDITION
an operation that has already been terminated with a
occurs in "cleanup" activity following an operation that was terminated by
. The command for which
RELEASE
unlikely to be the cause of the deferred error. It simply gives the drive the opportunity
to report
CHECK CONDITION
1 The Mark bit is set to 1 if a
a filemark was read. This bit may only be set if the sense key is
1 The End of Medium flag is set if a
the early warning area. If no other error occurred, the sense code will be set to
with additional sense of 0002h (EOT). If another error occurred, the sense code
SENSE
and additional sense will reflect that error. It is also set if BOP is encountered while
spacing over blocks or filemarks in the reverse direction.
1 Indicates that the requested block length did not match the actual block length. Only
and can cause this bit to be set.
READ VERIFY
page 135
never truncated to reflect the actual Transfer Length.
0 Provides additional information specific to the failing command. The field is normally
set to 0.
page 136
.
0 The Sense Key Specific Bytes (bytes 15 through 17) are invalid. The C/D, BPV and Bit
pointer fields will be zero. The top byte of the Field Pointer will be zero, and the
bottom byte will contain a product-specific error code.
status has been reported.
CHECK CONDITION
status for an error that already exists.
, or
SPACE READ VERIFY
or
WRITE
for details of sense keys that can be returned.
, ,
READ WRITE WRITE FILEMARKS
REQUEST SENSE
status, or when failure
GOOD
status was reported is therefore
command did not complete because
NO SENSE
command completed in
WRITE FILEMARKS
or command. The field
SPACE
CHECK CONDITION
is unsolicited. See "Additional Sense
BUS
.
NO
, or