Table of Contents
Advertisement
Code
SCSI bus reset
29 02h
Bus device reset
29 03h
29 04h Internal firmware reboot
Transceivers to SE
29 05h
29 06h Transceivers to LVD
Mode parameters changed
2A 01h
30 00h Incompatible medium installed
Unknown format
30 01h
30 02h Cannot read media: incompatible format
Cleaning cartridge installed
30 03h
30 04h Cannot write medium
Cleaning failure
30 07h
31 00h Medium format corrupted
Unsupported enclosure function
35 01h
35 02h Enclosure services unavailable
Rounded parameter
37 00h
3A 00h Medium not present
Media Auxiliary Memory not ready to access MAM is not ready to be accessed. This is likely to be
3A 04h
138 Commands
Description
Explanation
SCSI drives:
The drive has received a SCSI reset signal
since the host last accessed it.
FC drives:
The drive has received its first process login.
The drive will be implicitly logged out after a Target Reset
so this ASCQ will be posted after the host has performed
port/process login.
SCSI drives:
The drive has received a SCSI bus device
reset message since the host last accessed it.
FC drives:
The drive has received a process login when it
was previously logged in for a particular host.
The drive has reset itself.
SCSI drives:
The transceivers on the bus have been reset
to Single-Ended.
SCSI drives:
The transceivers on the bus have been reset
to LVD.
The Mode parameters for the drive have been changed
by an initiator other than the one issuing the command.
A write-type operation could not be executed because it is
not supported on the type of tape that is loaded.
An operation could not be carried out because the tape in
the drive is of a format not supported by the drive.
An operation could not be completed because the logical
format is not correct.
An operation could not be carried out because the tape in
the drive is a cleaning cartridge.
An attempt was made to write to a cartridge that has
Cartridge Memory errors.
A cleaning operation was attempted but could not be
completed for some reason.
Data could not be read because the format on tape is not
valid, although it is in a known format.
The drive cannot respond to this Enclosure Services
request.
No compatible enclosure hardware has been detected by
the drive.
A
command parameter has been rounded
MODE SELECT
because the drive cannot store it with the accuracy of the
command.
A media-access command has been received when there
is no tape loaded.
because there is no cartridge present.
Advertisement
Table of Contents
