Area Full Reset Setting - Sanyo DSR-3000 Instruction Manual

RECORDING AREA SET SETTING
6
Turn the shuttle dial counterclockwise.
The screen changes to show a "WARNING" display. This is a
message to warn you that the hard disk is about to be reinitialized.
7
To reinitialize the hard disk, turn the jog dial to display
" YES" , and then turn the shuttle dial clockwise.
The RECORDING AREA SET screen appears and the recording
capacities for each area are changed.
Note: If you turn the shuttle dial clockwise when "NO" is selected, the
RECORDING AREA SET screen appears and the recording
capacities return to their previous settings. The hard disk is not
reinitialized in this case.

AREA FULL RESET setting

When the normal recording area and alarm recording area of the hard
disk become full, the images in the recording areas will be
automatically overwritten, starting from the oldest images that have
been recorded.
However, you can change this setting to prevent overwriting of images
when the recording areas become full, at times such as when you
want to check or edit the recorded images. In this case you need to
specify each time that you want images to be overwritten in each
recording area. The following procedure describes the method of
doing this.
1
Set the OVERWRITE setting for the NORMAL RECORDING
AREA or ALARM RECORDING AREA to " OFF" in the
RECORDING CONDITIONS SET menu.
This setting can be used to display the remaining recording area
of the hard disk on the screen. At the same time, the FULL or
ALARM FULL indicator at the front of the digital video recorder
will flash.
When writing to the hard disk is complete, you can use playback
operations to check the recordings.
<WARNING>
THIS CHANGE WILL INITIALIZE THE DISK.
ALL RECORDING WILL BE ERASED.
ARE YOU SURE ?
NO
CHANGE WITH JOG. SET WITH SHUTTLE
<WARNING>
THIS CHANGE WILL INITIALIZE THE DISK.
ALL RECORDING WILL BE ERASED.
ARE YOU SURE ?
YES
CHANGE WITH JOG. SET WITH SHUTTLE
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : OFF
TOTAL NUMBER : **
RECORDING NUMBER : **
NORMAL RECORDING AREA
OVERWRITE : ON
ALARM RECORDING AREA
OVERWRITE : ON
REMAINING DISK WARNING : **
2
Use the jog dial to move the cursor to the AREA FULL
RESET → setting for the NORMAL RECORDING AREA, and
then turn the shuttle dial clockwise.
"NO" flashes on the WARNING screen.
3
Use the jog dial to change " NO" to " YES" , and then turn the
shuttle dial clockwise.
The NORMAL RECORDING AREA is set to single overwriting.
4
Follow the same procedure to make the setting for the
ALARM RECORDING AREA.
5
Press the EXIT/OSD button.
The display returns to the normal screen.
EXIT/OSD
Note:
•
For overwriting to be carried out automatically, change the
OVERWRITE setting for the NORMAL RECORDING AREA or
ALARM RECORDING AREA to "ON".
•
If AREA FULL RESET is carried out, the normal recording area,
alarm recording area and archive area will all be reinitialized, and it
will no longer be possible to play back any images that have
already been recorded.
46
<RECORDING AREA SET>
TOTAL CAPACITY : 80GB
NORMAL RECORDING AREA : 80 %
AREA FULL RESET ->
ALARM RECORDING AREA : 19 %
AREA FULL RESET ->
ARCHIVE AREA : 1 %
AREA FULL RESET ->
CAUTION : WHEN THE AREA SETTING IS CHANGED.
THE WHOLE AREA WILL BE INITIALIZED !
<WARNING>
AREA FULL RESET
NORMAL RECORDING AREA
ARE YOU SURE ?
NO
CHANGE WITH JOG. SET WITH SHUTTLE
English