Sanyo DSR-3000 Instruction Manual page 33

SEARCHING FOR RECORDED IMAGES
Use the jog dial to move the cursor to PREVIEW, and then
10
turn the shuttle dial clockwise. The screen showing the
motion sensor settings appear in the preview screen each
2
time the shuttle dial is turned.
1
Note: If no motion sensor settings have been made, "NOT FOUND" appears, so
To view a motion sensor setting in a single-screen display,
11
use the jog dial to move the cursor to VIEW and then turn
the shuttle dial clockwise.
2
The display changes from the specified image to normal playback.
1
Note: When using a multiplexer and the camera number has been specified as a
make sure that the motion sensor settings have been made correctly.
channel when carrying out motion detector searches, only images for the
specified camera number will be played back. For playback of all cameras
the playback has first to be switched off and then switched on again.
Furthermore, the multiplexer title information and date information may not
be fully displayed at this time in some cases.
32
<MOTION DETECTION SEARCH>
SEARCH FROM : NORMAL / CHANNEL : 4
START :
10-28-01 10:00
END :
10-28-01 20:00
MOTION SENSOR ->
PREVIEW ->
VIEW ->
MOVE:JOG SELECT:SHUTTLE
English