Table of Contents
Advertisement
5.2.1 Gigabit Ethernet 1000Base-Tx Cabling Recommendations
The IEEE 802.3ab Gigabit Ethernet standard defines 1000Mbit/s Ethernet communications over
distances of up to 100 meters using 4 pairs of category 5 (or higher) balanced unshielded twisted-
pair cabling. For wiring guidelines, system designers and integrators should refer to the
Telecommunications Industry Association (TIA) TIA/EIA-568-A wiring standard that characterizes
minimum cabling performance specifications required for proper Gigabit Ethernet operation. To
ensure reliable, error-free data communications, new and pre-existing communication paths should
be verified for TIA/EIA-568-A compliance. Table 7 summarizes cabling standards available today.
Cabling
1000BaseTx
Category
Compliant
< 5
No
5
Yes
5e
Yes
6
Yes
> 6
Yes
Table 7: Cabling categories and 1000BaseTx compliance defined.
In general the following recommendations should be followed for copper data cabling in high
electrical noise environments:
• Data cable lengths should be as short as possible, ideally limited to 3m (10ft) in length.
Copper data cables should not be used for inter-building communications.
• Power and data cables should not be run in parallel for long distances, and ideally should be
installed in separate conduits. Power and data cables should intersect at 90° angles when
necessary to reduce inductive coupling.
• Shielded/screened cabling can optionally be used. The cable shield should be grounded at
one single point to avoid the generation of ground loops.
©
2008 RuggedCom Inc. All rights reserved
New wire infrastructure required
Verify TIA/EIA-568-A compliance
No action required. New installations should be designed with
Category 5e components or higher
No action required
Connector and cabling standards to be determined.
24
Required action
Rev105
Advertisement
Table of Contents
